• Welcome to XOTIC PC Forums! If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.


No announcement yet.

Sager NP2092 video blank during boot issues

  • Filter
  • Time
  • Show
Clear All
new posts

  • Sager NP2092 video blank during boot issues

    I have a new NP2092 with 4GB RAM, running Vista Ultimate x64 which has been great so far. But from time to time the screen goes blank while Vista is loading and it never comes to the ctrl-alt-del screen. You have to power off the laptop and power on and it usually always loads ok following that although you get the "Unexpected Shutdown Detected" screen and Vista reports the system did not shutdown properly. The issue has been happening more frequently lately so I decided to uninstall the nvidia drivers and replace with the microsoft and it appears fixed. Has anyone else had this issue? I haven't researched it much. I was using the current nvidia vista x64 drivers from the support site version 167.59.
    Sager NP2092 T9300 4GB 320GB Vista x64

  • #2
    Iím sorry to hear that you are having problems with the notebook. I would recommend contacting technical support at 1-(800) 741-2219 (9AM - 5PM PST) OR 1-(877) 645-9312 (24/7 Domestic Tech Support)


    • #3
      This is sometimes caused by any exterior devices that are plugged in at the time. I have had this happen seldomly, but I am not entirely sure of its cause. I think it may be an issue that Sager should investigate.
      Sager NP5792

      Microsoft Windows Vista Premium 64-Bit
      17" WUXGA
      Intel Core 2 Duo T7700 2.4GHz
      4 GB DDR2 667 RAM
      1 GB Intel Robson Turbo Memory
      500 GB 7200RPM Seagate Momentus HD
      nVidia GeForce 8800M GTX 512MB GDDR3